Installation Instructions for Street Glide models through 2013
The fairing shell will have to be removed to enable access to the plug end at the end of the turn signal wires.
The deflectors install by removing the front turn signals, threading the fixture into the deflector while routing the wire to the turn signal through the small pre-drilled hole in the deflector then reinstalling the two pieces back onto the side of the down tubes.
The opening for the turn signal should have a consistent reveal around the lens and fixture. There is a small amount of adjustment available to center the fixture in the opening.
Reroute the turnsignal wire back to the factory connection. Test the turn signals prior to re-installation of the fairing shell
All GADS deflectors are made of Polycarbonate plastic and are extremely durable, they should give you many years of trouble free service.
Bob the GADS guy
Touring Platform 2014 And Up
Lower Triple Tree Deflector
Remove the protective coating.
Fasten the GADSLT14 to the lower triple tree, using the bolts that hold the fork slider cover.
Apply a small amount of thread lock to bolts and torque to a snug fit
Do not over tighten
(DOES NOT FIT TRI-GLIDE)