SGADS
Installation 2014 and up STREET GLIDE deflectors,
(this requires the included hardware package) 4 stainless 5/16” bolts, 4 spacers, 4 washers
Remove the turnsignal brackets, disconnect the small wiring connector, remove the studs set aside save and reuse the washers.
The wiring plug for the signal fit through a 1” hole in the triple tree cover. Thread the wire through the corresponding hole in the deflector. Refasten the connection through the deflector to the wire on the back of the bracket. Put a washer on 2 bolts, fit through the turn signal bracket, install a spacer on the bolts, inside the brackets while not pinching the turn signal wires.
Loosely install the deflector to the corresponding holes on the side of the triple tree. The deflector has some adjustment built in to center the turn signal in the opening.
Check for fitment and pinched wiring as you tighten to specified in the service manual. Over tightening may result in stress fractures in the polycarbonate.
___________________________________________________________________
All GADS deflectors are made of Polycarbonate plastic and are extremely durable, they should give you many years of trouble free service.
Bob the GADS guy